Kingston Memory KVR16N11S6/2 2GB DDR3 1600 Retail

$15.80

In stock

SKU: 148580 Categories: ,

Description

This document describes ValueRAM’s 256M x 64-bit (2GB) DDR3-1600 CL11 SDRAM (Synchronous DRAM) 1Rx16,
memory module, based on four 256M x 16-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.5V. This 240-pin DIMM uses gold contact fingers. The electrical and mechanical specifications are as follows:

Features:

• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply

• VDDQ = 1.5V (1.425V ~ 1.575V)

• 800MHz fCK for 1600Mb/sec/pin

• 8 independent internal bank

• Programmable CAS Latency: 11, 10, 9, 8, 7, 6

• Programmable Additive Latency: 0, CL – 2, or CL – 1 clock

• 8-bit pre-fetch

• Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]

• Bi-directional Differential Data Strobe

• Internal (self) calibration: Internal self calibration through ZQ pin (RZQ: 240 ohm ± 1%)

• On Die Termination using ODT pin

• Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C • Asynchronous Reset • PCB: Height 1.180” (30.00mm), single sided component

CL (IDD)
11 Cycles

Row Cycle Time (tRCmin)
48.125ns (min)

Refresh to Active/Refresh Command Time (tRFCmin)
260ns (min)

Row Active Time (tRASmin)
36ns (min)

Maximum Operating Power
1.170W

UL Rating
94V to 0

Operating Temperature
0 C to 85 C

Storage Temperature
-55 C to +100 C

Item Dimension (L”xW”xH”)
2.17 6.7 x 0.52

Weight
0.25 lb

Warranty Information
Lifetime Manufacture

Additional information

Weight 0.25 lbs
Status

ACTIVE

Vendor

Kingston

Item ID

KVR16N11S6/2